TESTING OF CERAMIC CUTTING TOOLS WITH AN INTERRUPTED CUT SIMULATOR

Authors

  • Robert Cep
  • Branimir Barišić

Abstract

This article presents a solution for ceramic cutting tools availability in interrupted machining. Experiments were performed on a special fixture—the interrupted cut simulator. This fixture was constructed at our Department of Machining and Assembly within the scope of a project by the Czech Science Foundation. The goals of the tests were to contribute to the wider usage of these cutting materials in machining, especially in interrupted machining. Through the centuries, producers of ceramic cutting tools have taken big steps forward. Namely, increasing durability in maintaining high levels of strength and hardness lends an advantage. Some producers of these materials advise cutting inserts for interrupted machining at the present time [1,2].

Author Biographies

Robert Cep

Technical University of Ostrava, Faculty of Mechanical Engineering

Branimir Barišić

Faculty of Engineering, University of Rijeka, Rijeka, Croatia

Downloads

Published

2008-07-01

Issue

Engineering Review Vol 28. No. 1

Section

Articles

License

Engineering review uses the Creative Commons Attribution-NonCommercial-NoDerivatives (CC-BY-NC-ND) 4.0 International License, which governs the use, publishing and distribution of articles by authors, publishers and the wider general public.

The authors are allowed to post a digital file of the published article, or the link to the published article (Enginering Review web page) may be made publicly available on websites or repositories, such as the Author’s personal website, preprint servers, university networks or primary employer’s institutional websites, third party institutional or subject-based repositories, and conference websites that feature presentations by the Author(s) based on the published article, under the condition that the article is posted in its unaltered Engineering Review form, exclusively for non-commercial purposes.

The journal Engineering Review’s publishing procedure is performed in accordance with the publishing ethics statements, defined within the Publishing Ethics Resource Kit. The Ethics statement is available in the document Ethics Policies.