Research on the grinding performance of high pressure sintering SiCp/Al matrix composites
Keywords:
SiCp/Al composite, grinding performance, grinding morphologyAbstract
The two-dimensional vertical grinding test equipment was used to grind SiCp/Al composites which were prepared by high pressure sintering method. The SEM observation of grinding morphology showed that grinding damage can be prevented by SiC particles reinforcement, 60% volume fraction of SiC particles of SiCp/Al composite can hinder grinding depth and grinding performance was improved with the sintering pressure and temperature increasing. In addition, some scratches and exfoliated pits of SiC particles were observed on the surface of 60% volume SiCp/Al composite as the increase of grinding grain, while the depth of these scratches was shallower, there was no large area exfoliated pits of SiC reinforcements.Downloads
Published
Issue
Section
License
Engineering review uses the Creative Commons Attribution-NonCommercial-NoDerivatives (CC-BY-NC-ND) 4.0 International License, which governs the use, publishing and distribution of articles by authors, publishers and the wider general public.
The authors are allowed to post a digital file of the published article, or the link to the published article (Enginering Review web page) may be made publicly available on websites or repositories, such as the Author’s personal website, preprint servers, university networks or primary employer’s institutional websites, third party institutional or subject-based repositories, and conference websites that feature presentations by the Author(s) based on the published article, under the condition that the article is posted in its unaltered Engineering Review form, exclusively for non-commercial purposes.
The journal Engineering Review’s publishing procedure is performed in accordance with the publishing ethics statements, defined within the Publishing Ethics Resource Kit. The Ethics statement is available in the document Ethics Policies.