Sensitivity Optimization Method for 4th Order CBQ Structure LP Filter

Authors

  • Even Živić Technical Department, Tehnomont Shipyard Pula Ltd., Fižela 6, 52100 Pula, Croatia
  • Nino Stojković University of Rijeka, Faculty of Engineering, Vukovarska 58, 51000 Rijeka, Croatia
  • Saša Sladić University of Rijeka, Faculty of Engineering, Vukovarska 58, 51000 Rijeka, Croatia

Abstract

In this paper, design and optimization method for 4th order low-pass filter designed as a cascade of biquarts and approximated according to Butterworth has been depicted. Schoeffler sensitivity, multi-parameter sensitivity measure and Monte Carlo analysis were used for sensitivity measure, filter tuning and optimization confirmation. Limitations in filter characteristic due to Butterworth approximation are also presented, together with optimization limitation in order to have narrow filter element value range. To confirm optimization method, three different types of optimization parameters were used. Finally, 4th order low pass filter with cascade of biquarts structure was compared to 4th order filter without feedback and confirmed to have lower sensitivity.

Downloads

Published

2022-12-17

Issue

Engineering Review, Vol. 42, No. 2

Section

Articles

License

Copyright 2022 by Faculty of Engineering University of Rijeka, Faculty of Civil Engineering University of Rijeka. All rights reserved. This material may not be reproduced or copied, in whole or in part, in any printed, mechanical, electronic, film, or other distribution and storage media without the written consent of the publisher.

The journal Engineering Review’s publishing procedure is performed in accordance with the publishing ethics statements, defined within the Publishing Ethics Resource Kit. The Ethics statement is available in the document Ethics Policies.