CREATING A PALETTE BOW TIPPER WITH TECHNOLOGY OF DEFORMATION

Authors

  • Dejan Deželjin
  • Branimir Barišić
  • Tibor Szalay
  • Marko Kršulja

Abstract

Work shows the entire process of palette bow tipper construction. The process of modeling, preparation and the process of production are described. Parts were prepared for processing on machines by the use of CAD/CAM software following the rules of deformation technology. With the demonstrated procedure, the production process was optimized, and the production process was accelerated and controlled in all production steps. Modeling and simulation were performed by the use of the software SolidWorks. Then the model was separated into sections that were transported in the software ToPs 300, where the optimum use of sheet metal panels was planned and carried out. In this work, the basic rules of modeling and some technological solutions during the execution of the bow tipper palette are demonstrated.

Author Biographies

Dejan Deželjin

Faculty of engineering, University of Rijeka, Rijeka, Croatia

Branimir Barišić

Faculty of engineering, University of Rijeka, Rijeka, Croatia

Tibor Szalay

Budampest University of Technology and Economics Department of Manufacturing Science and Technology

Marko Kršulja

Faculty of engineering, University of Rijeka, Rijeka, Croatia

Downloads

Published

2009-01-15

Issue

Section

Articles