DETERMINATION OF TECHNOLOGICAL PARAMETERS LIMIT VALUES ON PLANNED EXPERIMENT, PROPOSAL FOR FOLLOWING PRODUCTS FROM THERMOPLASTICS QUALITATIVE PARAMETERS

Authors

  • Jozef Dobransky
  • Emil Ragan
  • Naqib Daneshjo

Abstract

The contribution concerns the determination of the technological parameters limit values necessary for the planned experiment proposal, where the influence of single technological parameters will be observed. Technological parameters in mutual interaction influence the resulting quality of thermoplastics products produced through the technology of injection molding. The three distinct technological parameters that were used mainly in mutual interaction influencing qualitative characteristics of the products in manufacturing process were chosen from the technological parameters set. During experimental measurement, the value of one technological parameter was always changed. At every change, experimental samples were produced and then were measured and evaluated.

Author Biographies

Jozef Dobransky

echnical University in Košice, Faculty of Manufacturing Technologies, Prešov, Slovak Republic

Emil Ragan

echnical University in Košice, Faculty of Manufacturing Technologies, Prešov, Slovak Republic

Naqib Daneshjo

echnical University in Košice, Faculty of Manufacturing Technologies, Prešov, Slovak Republic

Downloads

Published

2009-12-01

Issue

Engineering Review Vol 29. No. 2

Section

Articles

License

Engineering review uses the Creative Commons Attribution-NonCommercial-NoDerivatives (CC-BY-NC-ND) 4.0 International License, which governs the use, publishing and distribution of articles by authors, publishers and the wider general public.

The authors are allowed to post a digital file of the published article, or the link to the published article (Enginering Review web page) may be made publicly available on websites or repositories, such as the Author’s personal website, preprint servers, university networks or primary employer’s institutional websites, third party institutional or subject-based repositories, and conference websites that feature presentations by the Author(s) based on the published article, under the condition that the article is posted in its unaltered Engineering Review form, exclusively for non-commercial purposes.

The journal Engineering Review’s publishing procedure is performed in accordance with the publishing ethics statements, defined within the Publishing Ethics Resource Kit. The Ethics statement is available in the document Ethics Policies.