THE ROUNDNESS DEVIATION MEASUREMENT WITH COORDINATE MEASURING MACHINES

Authors

  • Bartosz Gapinski
  • Miroslaw Grezelka
  • Miroslaw Ruck

Abstract

In the article, the form deviation (roundness) measurement with the Coordinate Measuring Machine has been discussed. The influence of the measuring points number and the type of the roundness deviation on the result (since different fitting elements are used) has been presented. The obtained investigation results prove that a minimal number of points is not enough for measurement, while too large of a number does not improve the measurement, as well. A recommendation on the measuring points number has been given.

Author Biographies

Bartosz Gapinski

Poznan University of Tehnology, Division of Metrology and Measuring Systems

Miroslaw Grezelka

Poznan University of Tehnology, Division of Metrology and Measuring Systems

Miroslaw Ruck

Poznan University of Tehnology, Division of Metrology and Measuring Systems

Downloads

Published

2006-12-15

Issue

Engineering Review Vol 26. No. 1/2

Section

Articles

License

Engineering review uses the Creative Commons Attribution-NonCommercial-NoDerivatives (CC-BY-NC-ND) 4.0 International License, which governs the use, publishing and distribution of articles by authors, publishers and the wider general public.

The authors are allowed to post a digital file of the published article, or the link to the published article (Enginering Review web page) may be made publicly available on websites or repositories, such as the Author’s personal website, preprint servers, university networks or primary employer’s institutional websites, third party institutional or subject-based repositories, and conference websites that feature presentations by the Author(s) based on the published article, under the condition that the article is posted in its unaltered Engineering Review form, exclusively for non-commercial purposes.

The journal Engineering Review’s publishing procedure is performed in accordance with the publishing ethics statements, defined within the Publishing Ethics Resource Kit. The Ethics statement is available in the document Ethics Policies.